1. Bubbling issues:
Few laminator problems look worse than bubbles under the film. Bubbles are caused by a lot of problems: insufficient tension on the supply roll; feeding the leading edge of the print too quickly into the laminator; too much heat on a wet print, causing "outgassing" of the ink; the laminating adhesive not bonding properly to the media, and others. Insufficient tension causes bubbles when air get trapped between the film and image because the film wasn't taut as it entered the nib. Feeding too quickly causes bubbles if the item is pushed into the nip faster than la vitesse de la plastifieuse.
L'argenture est causée par la capture de minuscules bulles d'air. Cela ressemble à une zone floue ou réfléchissante dans la stratification. Il peut passer inaperçu sur les zones claires d'une image, mais sera plus évident sur les zones sombres ou noires. L'argenture est plus souvent observée lorsqu'une machine n'a pas le temps de se réchauffer ou si la température du film chute trop bas. Lorsqu'une grande machine est réchauffée sans le moteur allumé, un côté de chaquerouleau de laminage remains relatively cool.
When laminage is begun, a pattern of repeated silvering can be seen each time the cool side of a roller is applied to the lamination.
2. Problèmes de rides :
Le film se froissera si la tension du rouleau d'alimentation n'est pas suffisante. Toute plastifieuse a besoin d'une certaine résistance au déroulement des rouleaux d'alimentation afin que le film repose à plat lorsqu'il pénètre dans l'emprise des rouleaux de plastification. Un film stratifié plus fin nécessite moins de tension, plus épais film laminate needs more.
3. Problèmes de peau d'orange :
Refers to the very fine wrinkles or waves in the laminate. This is a common condition of using too much heat. Simply adjust the temperature to a lower setting.
